Tundra 4WD V8-5.7L (3UR-FE) (2007)
(a)
Temporarily install the upper side of the shock absorber to the chassis frame with the 4 nuts.
(b) Temporarily install the lower side of the shock absorber to the lower suspension arm with the bolt, washer and nut.
2. STABILIZE SUSPENSION
(a)
Lower the vehicle.
(b) Press down on the vehicle several times to stabilize the suspension.
3. TIGHTEN FRONT SHOCK ABSORBER WITH COIL SPRING
(a)
Tighten the nut.
Torque: 195 Nm (1988 kgf-cm, 144 ft. lbs.)
(b) Tighten the 4 upper nuts in diametrically opposite pairs.
Torque: 45 Nm (459 kgf-cm, 33 ft. lbs.)
(c)
Check that the first nut that was tightened is at the torque specification.