Tundra 4WD V8-5.7L (3UR-FE) (2007)
Standard resistance
(b) Connect the battery's positive (+) lead to the terminal of the solenoid valve connector, and the negative (-) lead to the solenoid valve body.
Then check that the valve moves and makes an operating noise.
OK: Valve moves and makes an operating noise.
If the result is not as specified, replace the solenoid valve.
Component without harness connected: (Shift Solenoid Valve SL2)
6. INSPECT SHIFT SOLENOID VALVE SL2
(a)
Measure the resistance according to the value(s) in the table below.
Standard resistance
(b) Connect the battery's positive (+) lead with a 21 W bulb to terminal 1 and the negative (-) lead to terminal 2 of the solenoid valve connector.
Then check that the valve moves and makes an operating noise.
OK: Valve moves and makes an operating noise.
If the result is not as specified, replace the solenoid valve.