Tundra 4WD V8-5.7L (3UR-FE) (2007)
/Page-1172012.png)
Component without harness connected: (Shift Solenoid Valve SLU
9. INSPECT SHIFT SOLENOID VALVE SLU
(a)
Measure the resistance according to the value(s) in the table below.
Standard resistance
(b) Connect the battery's positive (+) lead with a 21 W bulb to terminal 2 and the negative (-) lead to terminal 1 of the solenoid valve connector.
Then check that the valve moves and makes an operating noise.
OK: Valve moves and makes an operating noise.
If the result is not as specified, replace the solenoid valve.
REASSEMBLY
1. INSTALL SHIFT SOLENOID VALVE S3
(a)
Install the shift solenoid valve with the bolt.
Torque: 10 Nm (102 kgf-cm, 7 ft. lbs.)
