Tundra 4WD V8-5.7L (3UR-FE) (2007)
B. Measure backlash from the pinion gear flange as shown in Figure 22.
Specification: 0.36 to 0.52 mm (0.014 to 0.020 in.)
NOTE
^ The dial indicator must be at a 90 degree angle to the stud.
^ Be sure the ring gear does NOT move during backlash inspection.
12. Measure the total pre-load.
A. Using the SST measure the total pre-load.
SST: 00002-02955
Standard Total Pre-load (at starting):
3.47 to 4.58 N*m (36 to 45 kgf*cm, 31 to 39 in*lbf)
B.
Repeat steps 7 - 12 until backlash and pre-load are within specification.
NOTE
Multiple washer changes and inspections may be required. Changing the washers can be a trial and error process until the backlash and pre-load
are correct.
13. Separate the differential housing and apply seal packing.
A. Be sure contact surfaces are clean.