Tundra 4WD V8-5.7L (3UR-FE) (2007)
/Page-1235017.png)
For Differential Side
(e)
Align the matchmarks on the flange yoke and differential flange.
(f)
Install the propeller shaft to the differential side with the 4 bolts and 4 nuts.
Torque: 70 Nm (714 kgf-cm, 52 ft. lbs.)
3. ADJUST NO. 1 CENTER SUPPORT BEARING ASSEMBLY (for 3 Joint Type)
(a)
Adjust dimension "A" between the front surface of the center bearing and the back surface of the intermediate shaft as shown in the
illustration. Refer to the following Center Bearing Adjustment Criteria table.
