Tundra 4WD V8-5.7L (3UR-FE) (2007)
^
If possible, use snap rings of the same thickness for both edges.
(f)
Insert the spider into the flange yoke, and then using SST, press in the spider bearing into the snap ring groove.
SST 09332-25010
HINT: Press in the spider bearing on the opposite side in the same way.
NOTICE: When pressing in the spider bearing, be careful not to damage its lip.
(g) Using needle-nose pliers, install new snap rings into the grooves of the yoke.
2. INSPECT FRONT PROPELLER SHAFT UNIVERSAL JOINT SPIDER BEARING
3. INSPECT FRONT PROPELLER SHAFT ASSEMBLY
HINT: When replacing the spider bearing, make sure that the grease fitting assembly hole is facing in the direction shown in the illustration.
INSTALLATION
1. INSTALL FRONT PROPELLER SHAFT