Tundra 4WD V8-5.7L (3UR-FE) (2007)
B.
Transfer Side:
Align the matchmarks on the flange yoke and transfer flange.
C.
Install the propeller shaft to the transfer side with the 4 nuts.
Torque: 70 N.m (714 kgf.cm, 52 ft.lbf)
D.
Differential Side:
Align the matchmarks on the flange yoke and differential flange.
E.
Install the propeller shaft to the differential side with the 4 bolts and 4 nuts.
Torque: 70 N.m (714 kgf.cm, 52 ft.lbf)
2.
Adjust the No.1 center support bearing assembly (for 3-joint type).
A.
Adjust dimension "A" between the front surface of the center bearing housing and the back surface of the intermediate shaft as shown in the