Tundra Access Cab LTD 2WD V8-4.7L (2UZ-FE) (2000)
1.
REMOVE FRONT WHEEL
2.
4WD:
REMOVE GREASE CAP
Using a screwdriver and hammer remove the grease cap.
3.
4WD:
DISCONNECT DRIVE SHAFT
A.
Remove the cotter pin and lock cap.
B.
While applying the brakes, remove the lock nut.
4.
W/ABS DISCONNECT ABS SPEED SENSOR AND WIRE HARNESS CLAMP FROM STEERING KNUCKLE
Remove the 2 bolts and disconnect the ABS speed sensor and wire harness clamp from the steering knuckle.
5.
DISCONNECT BRAKE LINE
Using the SST, disconnect the brake line. Use a container to catch the brake fluid.
^
09023-00100
6.
REMOVE BRAKE,CALIPER AND DISC