Tundra Access Cab LTD 2WD V8-4.7L (2UZ-FE) (2000)
Torque: 15 N.m (155 kgf.cm, 11 ft.lbf)
28.
W/ABS:
CONNECTABS SPEED SENSOR AND WIRE HARNESS CLAMP
Connect the ABS speed sensor and wire harness clamp to the steering knuckle with the 2 bolts.
Torque: 8.0 N.m (82 kgf.cm, 71 in.lbf)
29.
4WD:
INSTALL DRIVE SHAFT LOCK NUT
A. While applying the brakes, tighten the nut.
Torque: 235 N.m (2,400 kgf.cm, 173 ft.lbf)
B. Install the lock cap and a NEW cotter pin.
If the holes for the cotter pin are not aligned, tighten the nut further up to 600.
30.
2WD:
INSTALL GREASE CAP
31.
INSTALL FRONT WHEEL
NOTE:
Do NOT use air wrench.
Torque: 110 N.m (1,150 kgf.cm, 83 ft.lbf)
32.
DEPRESS BRAKE PEDAL SEVERAL TIMES
33.
FILL THE BRAKE RESERVOIR WITH BRAKE FLUID AND BLEED BRAKE SYSTEM
34.
CHECK ABS SPEED SENSOR SIGNAL (SEE REPAIR MANUAL)