Tundra Access Cab LTD 2WD V8-4.7L (2UZ-FE) (2000)
/Page-1054001.png)
Generator: Service and Repair
Disassembly and Reassembly
DISASSEMBLY
1. REMOVE REAR END COVER
a. Remove the nut and terminal insulator.
b. 70 A type:
Remove the 3 nuts and end cover.
c. 100 A type:
Remove the bolt 3 nuts, plate terminal and end cover.
2. REMOVE BRUSH HOLDER
a. 100 A type:
Remove the brush holder cover from the brush holder.
b. Remove the 2 screws and brush holder.
c. 70 A type:
Remove the brush holder cover from the brush holder.
d. 100 A type:
Remove the seal plate from the rectifier end frame.
