Tundra Access Cab LTD 2WD V8-4.7L (2UZ-FE) (2000)
Seals and Gaskets: Service and Repair
ON-VEHICLE REPAIR
1. REMOVE PROPELLER SHAFT
2. REMOVE REAR OIL SEAL
NOTICE: Clean the extension housing before removing the oil seal.
Using SST, remove the oil seal.
SST 09308-10010
3. INSTALL OIL SEAL
a. Using SST and a hammer, carefully drive a new oil seal in as far as it will go.
SST 09325-40010
b. Coat the lip of the oil seal with MP grease.
4. INSTALL PROPELLER SHAFT
5. CHECK FLUID LEVEL