Tundra Access Cab LTD 4WD V8-4.7L (2UZ-FE) (2001)
/Page-1493002.png)
a. Tie both piano wire ends to wooden blocks or similar objects.
b. Cut the adhesive tape by pulling the piano wire as shown in the illustration.
NOTE:
-
If reusing the moulding, take care not to damage the moulding.
-
Do not damage the body.
c. Remove the moulding.
INSTALLATION
1. CLEAN BODY MOUNTING SURFACE
a. Using a heat light, heat the body mounting surface to 40 - 60 °C (104 - 140 °F).
NOTE: Do not heat the body excessively.
b. Remove the adhesive tape from the body.
c. Wipe off stains with cleaner.
