Tundra Access Cab LTD 4WD V8-4.7L (2UZ-FE) (2001)
3. DISCONNECT BRAKE LINES
Using SST, disconnect the 5 or 6 brake lines from the master cylinder and 3-way or 4-way.
SST 09023-00100
Torque: 15 Nm (155 kgf-cm, 11 ft. lbs.)
4. REMOVE MASTER CYLINDER
(a) w/ ABS:
Remove the 2 nuts, wire harness bracket 3-way and check valve bracket.
Torque: 13 Nm (130 kgf-cm, 9 ft. lbs.)
(b) w/o ABS:
Remove the 2 nuts, wire harness bracket 4-way and check valve bracket.
Torque: 13 Nm (130 kgf-cm, 9 ft. lbs.)
(c) Pull out the master cylinder from brake booster.
INSTALLATION
Installation is in the reverse order of removal.
HINT:
-
Before installation, adjust length of brake booster push rod.
-
After installation, fill brake reservoir with brake fluid and bleed brake system.
-
Check for leaks, check and adjust brake pedal.