Tundra Access Cab LTD 4WD V8-4.7L (2UZ-FE) (2001)
/Page-1172003.png)
1. REMOVE GENERATOR DRIVE BELT
Loosen the belt tension by turning the belt tensioner counter-clockwise, and remove the drive belt.
HINT: The pulley bolt for the belt tensioner has a left-hand thread.
2. REMOVE PS VANE PUMP FROM ENGINE
3. REMOVE ENGINE UNDER COVER
4. REMOVE NO.2 FAN SHROUD
Remove the 2 clips and No.2 fan shroud.
5. REMOVE GENERATOR
a. Disconnect the generator connector.
b. Remove the cap and nut, and disconnect the generator wire.
c. Disconnect the generator wire clamp from the cord clip on the generator.
d. Remove the bolt, nut and generator.
INSTALLATION
1. INSTALL GENERATOR
a. Install the generator with the bolt and nut.
Torque: 39 N.m (400 kgf.cm, 29 ft.lbf)
b. Connect the generator connector.
c. Connect the generator wire with the nut and rubber.
d. Install the cap.
e. Install the generator wire clamp to the cord clip on the generator.
