Tundra Access Cab SR5 4WD V8-4.7L (2UZ-FE) (2001)
/Page-823004.png)
b. Reinstall a new accelerator pedal position sensor.
1. Check that the throttle valve is under the condition of the opener opening angle (about 4 °).
2. Install the sensor to the place where is at 20 ° rotated to the left from the specified installation position.
3. Gradually turn sensor clockwise until it touches the throttle valve shaft, and tighten the 3 set screws.
Torque: 5.4 N.m (55 kgf.cm, 48 in.lbf)
c. Inspect the accelerator pedal position sensor.
1. Connect the accelerator pedal position sensor connector.
2. Connect the TOYOTA hand-held tester or OBD II scan tool to the DLC3.
3. Turn the ignition switch ON.
NOTE: After turning the ignition switch ON, do not depress the accelerator pedal.
4. Check that the ACCEL POS #1 (VPA) voltage of the CURRENT DATA shows the standard value.
Standard accelerator pedal position voltage: 0.35 - 0.85 V
4. AFTER INSTALL THROTTLE BODY, INSPECT SYSTEM OPERATION
