Tundra Regular Cab 2WD V6-3.4L (5VZ-FE) (2000)
11.
4WD:
REMOVE OIL SEAL (INSIDE)
A.
Mount the axle hub in a soft jaw vise.
HINT:
Install nuts on the hub bolts, close the vise until it holds the hub nuts. Do not tighten further.
B.
Using a screwdriver, remove the oil seal (inside).
12.
2WD:
REMOVE LOCK NUT AND ABS
SPEED SENSOR ROTOR (W/ABS)
OR SPACER (W/O ABS)
Using a chisel and hammer, loosen
the staked part of the lock nut.
NOTE:
Be careful not to damage the bushing.
A.
Using the following SST, remove the lock nut.
00002-00909 (09318-12010)
NOTE:
Do NOT use air wrench.
B.
Remove the ABS speed sensor rotor or spacer.
NOTE:
Take care not to scratch the serration of the speed sensor rotor.
13.
REMOVE AXLE HUB FROM STEERING KNUCKLE
A.
Remove the 4 bolts and shift the dust cover toward the hub side (outside).
B.
Using the following SSTs, remove the axle hub from the steering knuckle.