Tundra Regular Cab 2WD V6-3.4L (5VZ-FE) (2000)
Engine Oil Pressure: Testing and Inspection
INSPECTION
1. CHECK ENGINE OIL QUALITY
Check the oil for deterioration, entry of water, discoloring or thinning.
If oil quality is visibly poor, replace it.
Oil grade:
API grade SJ, Energy-Conserving or ILSAC multi-grade engine oil. SAE 5W-30 is the best choice for your vehicle, for good fuel
economy, and good starting in cold weather.
2. CHECK ENGINE OIL LEVEL
The oil level should be between the "L" and "F" marks on the dipstick.
3. CHECK OIL LEVEL
The oil level should be between the "L" and "F" marks on the level gauge. If low, check for leakage and add oil up to the "F" mark. If low, check
for leakage and add oil up to the "F" mark.
NOTICE: Do not fill with engine oil above the "F" mark.
4. REMOVE OIL PRESSURE SWITCH
Using SST, remove the oil pressure switch.
SST 09816-30010
5. INSTALL OIL PRESSURE GAUGE
6. START ENGINE
Start the engine and warm it up to normal operating temperature.
7. CHECK OIL PRESSURE
Oil pressure:
8. REMOVE OIL PRESSURE GAUGE