Tundra Regular Cab 2WD V6-3.4L (5VZ-FE) (2000)
![background image](/toyota/tundra_regular_cab_2wd/v6-3.4l_(5vz-fe)/Page-1189001.png)
Compressor Clutch: Service and Repair
Removal and Installation
REMOVAL
1. RUN ENGINE AT IDLE SPEED WITH A/C ON FOR APPROX. 10 MINUTES
2. STOP ENGINE
3. DISCONNECT NEGATIVE (-) TERMINAL CABLE FROM BATTERY
4. DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM
5. 5VZ-FE engine:
REMOVE ENGINE UNDER COVER
6. 5VZ-FE engine:
DISCONNECT DISCHARGE AND SUCTION HOSES
Remove the 2 bolts and disconnect the both hoses.
NOTE: Cap the open fitting immediately to keep moisture or dirt out of the system.
7. 2UZ-FE engine:
DISCONNECT DISCHARGE AND SUCTION HOSES
Remove the 2 nuts and disconnect the both hoses.
NOTE: Cap the open fitting immediately to keep moisture or dirt out of the system.
8. REMOVE DRIVE BELT
9. 5VZ-FE engine:
REMOVE COMPRESSOR
a. Disconnect the connector.
b. Remove the 4 bolts and compressor.
10. 2UZ-FE engine:
REMOVE COMPRESSOR
a. Disconnect the connector.
b. Remove the 4 bolts and nut.
c. Remove the cooler bracket.
d. Remove the compressor.
INSTALLATION
1. 5VZ-FE engine:
INSTALL COMPRESSOR
a. Install the compressor with the 4 bolts.
Torque: 25 Nm (250 kg.cm, 18 in.lb)
b. Connect the connector.
2. 2UZ-FE engine:
INSTALL COMPRESSOR
a. Install the compressor with cooler bracket with the 4 bolts and nut.
Torque: 25 Nm (250 kg.cm, 18 in.lb)
b. Connect the connector.
3. 5VZ-FE engine:
CONNECT DISCHARGE AND SUCTION HOSES
Connect the both hoses with the 2 bolts.
Torque: 10 Nm (100 kg.cm, 7 in.lb)
NOTE: Hose should be connected immediately after the caps have been removed.
HINT: Lubricate 2 new O-rings with compressor oil and install them to the hoses.