Tundra Regular Cab 2WD V6-3.4L (5VZ-FE) (2000)
/Page-518002.png)
b. Using a 19 mm deep socket wrench, remove the ECT sensor and gasket.
4. INSPECT ECT SENSOR
Using an ohmmeter, measure the resistance between the terminals.
Resistance: Refer to the graph
If the resistance is not as specified, replace the ECT sensor.
5. REINSTALL ECT SENSOR
a. Install a new gasket to the ECT sensor.
b. Using a 19 mm deep socket, install the ECT sensor.
Torque: 20 Nm (200 kg.cm, 14 ft.lb)
c. Connect the ECT sensor connector.
6. REINSTALL FUEL PIPE
