Tundra Regular Cab 2WD V6-3.4L (5VZ-FE) (2000)
/Page-1123013.png)
4. INSTALL BUSHING
a. Coat a new O-ring with power steering fluid and install it to the bushing.
b. To prevent oil seal lip damage, wind vinyl tape on the steering rack end, and apply power steering fluid.
c. Install the bushing.
NOTICE: Make sure to install the bushing facing in the correct direction. Be careful not to damage the oil seal lip.
5. INSTALL CYLINDER END STOPPER
a. Align the installation hole for the wire of the stopper with the slot of the rack housing.
b. Install a new wire into the stopper.
c. Using SST, turn the stopper clockwise 450 ± 50°.
SST 09631-16010
6. AIR TIGHTNESS TEST
a. Install SST to the rack housing.
SST 09631-12071
b. Apply 53 kPa (400 mm g, 15.75 inch Hg) of vacuum for about 30 seconds.
c. Check that there is no change in the vacuum.
If there is change in the vacuum, check the installation of the oil seals.
7. INSTALL CONTROL VALVE ASSEMBLY
a. To prevent oil seal lip damage, wind vinyl tape on the serrated part of the valve shaft.
b. Coat the teflon rings with power steering fluid.
