Tundra Regular Cab 2WD V6-3.4L (5VZ-FE) (2000)
/Page-787001.png)
Shift Indicator: Pinout Values and Diagnostic Parameters
Except California
E1 ELECTRONICALLY CONTROLLED TRANSMISSION SOLENOID
1, 2, 3-GROUND : Approx. 13 Ohms
O4 O/D MAIN SW
3-1
: Open with O/D main SW at ON position Closed with O/D main SW at OFF position
S4 STOP LIGHT SW
1-2
: Closed with brake pedal depressed
E3(A), E4 (B), E5 (C), E6 (D) ENGINE CONTROL MODULE
S1-E1
: 9-14 volts with vehicle not move and shift lever in D position
S2,SL-El
: 0-1.5 volts with vehicle not move
STP-E1
: 7.5-14 volts with brake pedal depressed 0-1.5 volts with brake pedal released
THW-E1
: 0.2-1.0 volts with idling, engine coolant temp. 60° C (140° F) -120° C (248° F)
VTA-E1
: 0.3-1.0 volts with ignition SW on and throttle valve fully closed
: 3.2-4.9 volts with ignition SW on and throttle valve fully open
VC-E1
: 4.5-5.5 volts with ignition SW at ON or ST position
OD2-E1
: 9-14 volts with O/D main SW turned on
: 0-3 volts with O/D main SW turned off
SP1 -E1
: Pulse generation with vehicle moving
2-E1
: 7.5-14 volts with shift lever at 2 position
: 0-1.5 volts with shift lever at except 2 position
L-E1
: 7.5-14 volts with shift lever at L position
: 0-1.5 volts with shift lever at except L position
+B-E1
: 9-14 volts with ignition SW at ON or ST position
BATT-E1
: Always 9-14 volts
OIL-E2
: 0.1-0.9 volts after engine warm up
OD1-E1
: 9-14 volts with cruise control not operation
OILW-E1
: 0-1.5 volts with engine cranking at 400 rpm or more
P1 A/T INDICATOR SW [PARK/NEUTRAL POSITION SW]
3-1
: Closed with shift lever in P position
3-2
: Closed with shift lever in R position
3-5
: Closed with shift lever in N position
3-7
: Closed with shift lever in D position
3-4
: Closed with shift lever in 2 position
3-8
: Closed with shift lever in L position
General
E1 ELECTRONICALLY CONTROLLED TRANSMISSION SOLENOID
4, 7, 8-GROUND : Approx. 13 Ohms
O4 O/D MAIN SW
3-1
: Open with O/D main SW at ON position
: Closed with O/D main SW at OFF position
S4 STOP LIGHT SW
1-2
: Closed with brake pedal depressed
E3(A), E4 (B), ES (C), E6 (D), E7 (E) ENGINE CONTROL MODULE
S1-E1
: 9-14 volts with vehicle not move and shift lever in D position
S2,SL-E1
: 0-1.5 volts with vehicle not move
STP-E1
: 7.5-14 volts with brake pedal depressed
: 0-1.5 volts with brake pedal released
THW-E1
: 0.2-1.0 volts with idling, engine coolant temp. 60° C (140° F) -120° C (248° F)
OIL-E1
: Below 1.0 volts with fluid temp. 110° C (230° F)
VTA-E1
: 0.4-1.0 volts with ignition SW on and throttle valve fully closed
: 3.2-4.8 volts with ignition SW on and throttle valve fully open
VC-E1
: 4.5-5.5 volts with ignition SW at ON or ST position
OD2-E1
: 9-14 volts with O/D main SW turned on
: 0-3 volts with O/D main SW turned off
