toyota Workshop Repair Guides

Toyota Workshop Service and Repair Manuals

Output Shaft, A/T > < Component Tests and General Diagnostics|Page 2938
Page 2
background image

SPD-E1

: Pulse generation with vehicle moving

2-E1

7.5-14 volts with shift lever at 2 position
0-1.5 volts with shift lever at except 2 position 

L-E1

7.5-14 volts with shift lever at L position
0-1.5 volts with shift lever at except L position

+B-E1

9-14 volts with ignition SW at ON or ST position 

BATT-E1

: Always 9-14 volts

P1 A/T INDICATOR SW [PARK/NEUTRAL POSITION SW]

3-1

: Closed with shift lever in P position

3-2

: Closed with shift lever in R position

3-5

: Closed with shift lever in N position

3-7

: Closed with shift lever in D position

3-4

: Closed with shift lever in 2 position

3-8

: Closed with shift lever in L position

California Only

E1 ELECTRONICALLY CONTROLLED TRANSMISSION SOLENOID

1, 2, 3-GROUND : Approx. 13 Ohms

O4 O/D MAIN SW

3-1

: Open with O/D main SW at ON position 
: Closed with O/D main SW at OFF position

S4 STOP LIGHT SW

1-2

: Closed with brake pedal depressed

3(A), E4 (B), E5 (C), E6 (D) ENGINE CONTROL MODULE

S1-E1

9-14 volts with vehicle not move and shift lever in D position 

S2,SL-E1

0-1.5 volts with vehicle not move

STP-E1

7.5-14 volts with brake pedal depressed 
0-1.5 volts with brake pedal released

THW-E1

0.2-1.0 volts with idling, engine coolant temp. 60° C (140° F) -120° C (248° F)

VTA-E1

0.3-1.0 volts with ignition SW on and throttle valve fully closed 
3.2-4.9 volts with ignition SW on and throttle valve fully open

VC-E1

4.5-5.5 volts with ignition SW at ON or ST position 

OD2-E1

9-14 volts with O/D main SW turned on
0-3 volts with O/D main SW turned off 

SP1-E1

: Pulse generation with vehicle moving

2-E1

7.5-14 volts with shift lever at 2 position
0-1.5 volts with shift lever at except 2 position 

L-E1

7.5-14 volts with shift lever at L position
0-1.5 volts with shift lever at except L position

+B-E1

9-14 volts with ignition SW at ON or ST position 

BATT-E1

: Always 9-14 volts

OIL-E2

0.1-0.9 volts after engine warm up

OD1-E1

9-14 volts with cruise control not operation

OILW-E1

0-1.5 volts with engine cranking at 400 rpm or more

P1 A/T INDICATOR SW [PARK/NEUTRAL POSITION SW]

3-1

: Closed with shift lever in P position

3-2

: Closed with shift lever in R position

3-5

: Closed with shift lever in N position

3-7

: Closed with shift lever in D position

3-4

: Closed with shift lever in 2 position

3-8

: Closed with shift lever in L position

Output Shaft, A/T > < Component Tests and General Diagnostics|Page 2938