Tundra Regular Cab SR5 4WD V8-4.7L (2UZ-FE) (2000)
b. Make sure that the 2 boots are not stretched or contracted when the drive shaft is at standard length.
Drive shaft standard length: 523.5 ± 2.0 mm (20.610 ± 0.079 inch)
8. INSTALL LARGE INBOARD JOINT BOOT CLAMP TO INBOARD JOINT SHAFT BOOT
a. Place the large inboard joint boot clamp.
b. Using pliers, compress the clamp and attach the claws.
9. INSTALL OTHER BOOT CLAMPS TO BOTH BOOTS
a. Secure the clamp onto the boot.
b. Place SST onto the clamp.
SST 09521-24010
c. Tighten the SST so that the clamp is pinched.
NOTICE: Do not overtighten the SST.
d. Using SST, adjust the clearance of the clamp.
SST 09240-00020
Clearance: 1.0-1.5 mm (0.039-0.059 inch)
10. CHECK DRIVE SHAFT