Van Wagon 2WD L4-2237cc 2.2L (4Y-E) (1989)
Windshield Washer Relay: Testing and Inspection
Rear Motor & Relay
1.
Inspect low speed motor operation as follows:
a. Connect battery positive lead to terminal 3 and negative to motor body.
b. Ensure low speed motor operation.
2.
Inspect motor operation, stopping at stop position, as follows:
a. Connect battery positive lead to terminal 3 and negative to motor body.
b. Operate motor, then disconnect terminal 3 to stop motor operation.
c. Connect terminals 3 and 4.
d. Connect battery positive lead to terminal 2.
e. Ensure motor stops running at stop position after motor operates again.
f.
If operation is not as indicated, replace motor.