Van Wagon 2WD L4-2237cc 2.2L (4Y-EC) (1987)
The STATUS MONITOR LED turns on for 5 seconds.
NOTE:
YOU MUST PERFORM THE NEXT STEP WITHIN 5 SECONDS.
3. Press and hold the ECU's PROGRAMMING SWITCH for over 2 seconds again.
The STATUS MONITOR LED turns off, then flashes 3 times.
The Piezo chirper" chirps 3 times and the exterior lights flash 3 times
4.Turn off the ignition. The ECU has cleared all REMOTE CONTROL codes; until another REMOTE CONTROL is programmed, the system will
not work with any REMOTE CONTROL.