Venza AWD L4-2.7L (1AR-FE) (2009)
Text in Illustration
40. REMOVE REAR SEAT HEADREST ASSEMBLY (for RH Side) See: Seats/Service and Repair/Rear Seat Assembly (for RH Side)/Removal
41. REMOVE REAR SEAT CENTER HEADREST ASSEMBLY See: Seats/Service and Repair/Rear Seat Assembly (for RH Side)/Removal
42. REMOVE REAR SEAT INNER TRACK BRACKET COVER (for RH Side) See: Seats/Service and Repair/Rear Seat Assembly (for RH
Side)/Removal
43. REMOVE REAR SEAT OUTER TRACK BRACKET COVER (for RH Side) See: Seats/Service and Repair/Rear Seat Assembly (for RH
Side)/Removal
44. DISCONNECT REAR SEAT RECLINING CONTROL CABLE SUB-ASSEMBLY See: Seats/Service and Repair/Rear Seat Assembly (for RH
Side)/Removal
45. REMOVE REAR SEAT ASSEMBLY RH See: Seats/Service and Repair/Rear Seat Assembly (for RH Side)/Removal
46. REMOVE RECLINING REMOTE CONTROL BEZEL RH
HINT: Use the same procedure for the RH side and the LH side.
47. REMOVE LUGGAGE HOLD BELT STRIKER ASSEMBLY (for RH Side)
HINT: Use the same procedure for the RH side and the LH side.
48. DISCONNECT REAR SEAT OUTER BELT ASSEMBLY RH
HINT: Use the same procedure for the RH side and the LH side.
49. REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH
(a) Remove the bolt and clip.
(b) Disengage the 7 claws and 6 clips.
(c) Disconnect each connector and remove the deck trim side panel assembly RH.