Venza AWD L4-2.7L (1AR-FE) (2009)
Removal
BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: FRONT SPEED SENSOR: REMOVAL
REMOVAL
HINT:
-
Use the same procedure for the LH side and RH side.
-
The following procedure is for the LH side.
-
If the sensor rotor needs to be replaced, replace it together with the front drive shaft assembly.
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Repair Instruction - Initialization.
2. REMOVE FRONT WHEEL
3. REMOVE FRONT FENDER OUTSIDE MOULDING LH See: Body and Frame/Spoilers, Flaps, and Air Dams/Mud Flap/Service and
Repair/Removal
4. REMOVE FRONT FENDER LINER LH See: Body and Frame/Doors, Hood and Trunk/Hood/Hood Latch Release Cable/Service and
Repair/Removal
5. REMOVE FRONT SPEED SENSOR