Venza AWD L4-2.7L (1AR-FE) (2009)
/Page-1471004.png)
15. REMOVE LUGGAGE HOLD BELT STRIKER ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Headliner/Service and
Repair/Removal
16. DISCONNECT REAR SEAT OUTER BELT ASSEMBLY LH See: Restraint Systems/Seat Belt Systems/Seat Belt/Service and Repair/Rear Seat
Outer Belt Assembly/Removal
17. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal
18. REMOVE REAR SPEED SENSOR
(a) Disconnect the rear speed sensor connector.
Text in Illustration
(b) Disconnect the grommet of the rear speed sensor wire from the hole of the wheel house.
Text in Illustration
(c) Remove the 2 bolts, No. 1 clamp and No. 2 clamp from the body and absorber.
(d) Remove the bolt and rear speed sensor from the carrier.
NOTICE: Keep the sensor tip and rear speed sensor installation hole free from foreign matter.
Installation
BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: REAR SPEED SENSOR (for AWD): INSTALLATION
INSTALLATION
