Venza AWD L4-2.7L (1AR-FE) (2009)
Evaporator Temperature Sensor / Switch: Service and Repair
Installation
HEATING / AIR CONDITIONING: FRONT EVAPORATOR TEMPERATURE SENSOR: INSTALLATION
INSTALLATION
1. INSTALL NO. 1 COOLER THERMISTOR
(a) Install the No. 1 cooler thermistor as shown in the illustration.
Text in Illustration
NOTICE:
-
Be sure to insert the thermistor only once because reinserting it into the same position will not allow it to be firmly secured.
-
When reusing the evaporator, insert the thermistor one row next to the one that has been used previously (X in the illustration).
-
After inserting the thermistor, do not apply excessive force to the wire.
-
Directly insert the thermistor until the edge of plastic case "a" comes into contact with evaporator "b".
2. INSTALL COOLER EVAPORATOR SUB-ASSEMBLY See: Housing Assembly HVAC/Service and Repair/Reassembly
3. INSTALL BLOWER ASSEMBLY See: Blower Motor/Service and Repair/Blower Unit/Installation
4. INSTALL COOLER EXPANSION VALVE See: Housing Assembly HVAC/Service and Repair/Reassembly
5. INSTALL AIR CONDITIONING HARNESS ASSEMBLY (for Manual Air Conditioning System) See: Housing Assembly HVAC/Service and
Repair/Reassembly
6. INSTALL AIR CONDITIONING HARNESS ASSEMBLY (for Automatic Air Conditioning System) See: Housing Assembly HVAC/Service and
Repair/Reassembly
7. INSTALL NO. 2 AIR DUCT SUB-ASSEMBLY See: Housing Assembly HVAC/Service and Repair/Reassembly
8. INSTALL NO. 3 AIR DUCT SUB-ASSEMBLY See: Housing Assembly HVAC/Service and Repair/Reassembly
9. INSTALL NO. 2 FINISH PANEL MOUNTING BRACKET See: Housing Assembly HVAC/Service and Repair/Reassembly
10. INSTALL NO. 1 FINISH PANEL MOUNTING BRACKET See: Housing Assembly HVAC/Service and Repair/Reassembly
11. INSTALL AIR CONDITIONING UNIT ASSEMBLY
HINT: Refer to the procedure for Install Air Conditioning Unit Assembly See: Housing Assembly HVAC/Service and Repair/Installation.