Venza AWD L4-2.7L (1AR-FE) (2009)
(d) Install the 3 wire harness clamps.
2. INSTALL AIR CLEANER BRACKET
(a) Install the air cleaner bracket with the 2 bolts.
Torque: 7.8 Nm (80 kgf-cm, 69in-lbf)
3. INSTALL AIR CLEANER CASE SUB-ASSEMBLY See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and
Replacement/Engine Assembly/Installation
4. INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and
Replacement/Engine Assembly/Installation
5. INSTALL AIR CLEANER CAP SUB-ASSEMBLY See: Fuel Delivery and Air Induction/Throttle Body/Service and Repair/Installation
6. REMOVE NO. 1 VACUUM SWITCHING VALVE ASSEMBLY See: Emission Control Systems/Evaporative Emissions System/Canister Purge
Control Valve/Service and Repair/Installation
7. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and
Replacement/Engine Assembly/Installation
8. INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY See: Steering and Suspension/Suspension/Suspension Strut / Shock Absorber/Service
and Repair/Front Shock Absorber/Installation
9. INSTALL WINDSHIELD WIPER MOTOR AND LINK
(a) Install the windshield wiper motor and link See: Wiper and Washer Systems/Wiper Motor/Service and Repair/Front Wiper Motor/Installation.
10. INSTALL COOL AIR INTAKE DUCT SEAL See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine
Assembly/Installation
11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
CAUTION: When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Repair Instruction - Initialization.
12. PERFORM REGISTRATION
(a) The Vehicle Identification Number (VIN) must be input into a replacement ECM See: Computers and Control Systems/Testing and
Inspection/Programming and Relearning.