Venza AWD L4-2.7L (1AR-FE) (2009)
Impact Sensor: Testing and Inspection
Center Airbag Sensor Assembly
SUPPLEMENTAL RESTRAINT SYSTEMS: CENTER AIRBAG SENSOR ASSEMBLY: ON-VEHICLE INSPECTION
ON-VEHICLE INSPECTION
1. INSPECT CENTER AIRBAG SENSOR ASSEMBLY (VEHICLE NOT INVOLVED IN COLLISION)
(a) Perform a diagnostic system check See: Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/DTC Check / Clear.
2. INSPECT CENTER AIRBAG SENSOR ASSEMBLY (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT DEPLOYED)
(a) Perform a diagnostic system check See: Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/DTC Check / Clear.
3. INSPECT CENTER AIRBAG SENSOR ASSEMBLY (VEHICLE INVOLVED IN COLLISION AND AIRBAG IS DEPLOYED)
(a) Replace the center airbag sensor assembly.
CAUTION: Be sure to follow the correct removal and installation procedures of the center airbag sensor assembly.
HINT: The center airbag sensor assembly should be replaced after any of the airbags has deployed, as it has been subjected to an impact.