Venza AWD L4-2.7L (1AR-FE) (2009)
/Page-2019008.png)
SST: 09082-00700
CAUTION: When deploying the seat belt pretensioner, always use the specified SST.
(1) Connect the red clip of SST to a battery positive (+) terminal and the black clip to a battery negative (-) terminal.
HINT: At this time, do not connect the yellow connector. It will be connected to the seat belt pretensioner in later step.
(2) Press the SST deployment switch and check that the LED of the SST deployment switch illuminates.
CAUTION: If the LED is illuminated when the deployment switch is not pressed, SST may be malfunctioning. In this case, do not use
the malfunctioning SST.
(b) Connect SST.
(1) Connect 2 SST, and then connect them to the front seat outer belt pretensioner.
SST: 09082-00700
SST: 09082-00770
NOTICE: To avoid damaging the SST connector and wire harness, do not lock the secondary lock of the pretensioner connector.
(2) Place the outer belt on the ground and cover it with a tire and wheel assembly.
