Venza AWD L4-2.7L (1AR-FE) (2009)
Knock Sensor: Service and Repair
Installation
1AR-FE ENGINE CONTROL: KNOCK SENSOR: INSTALLATION
INSTALLATION
1. INSTALL KNOCK SENSOR
(a) Install the sensor with the bolt so that the sensor is angled as shown in the illustration.
Torque: 20 Nm (204 kgf-cm, 15ft-lbf)
NOTICE: The acceptable installation angle of the sensor is between 7° upward and 10° downward from the horizontal position.
(b) Connect the sensor connector.
2. INSTALL INTAKE MANIFOLD
(a) Install the intake manifold See: Engine, Cooling and Exhaust/Engine/Intake Manifold/Service and Repair/Installation.