Venza AWD L4-2.7L (1AR-FE) (2009)
Ignition Switch: Testing and Inspection
Engine Switch
1AR-FE STARTING: ENGINE SWITCH: INSPECTION
INSPECTION
1. INSPECT ENGINE SWITCH
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
If the result is not as specified, replace the engine switch.
(b) Apply battery voltage between the terminals of the switch, and check the illumination condition of the engine switch.
HINT:
-
If a positive (+) battery lead and a negative (-) battery lead are incorrectly connected, the engine switch indicator light will not illuminate.
-
If the voltage is too low, the indicator light will not illuminate.
OK:
Text in Illustration
If the result is not as specified, replace the engine switch.