Toyota Workshop Service and Repair Manuals

2. INSTALL WIRE HARNESS CLAMP BRACKET

(a) Install the clamp bracket with the bolt.

Torque: 10 Nm (102 kgf-cm, 7ft-lbf)

(b) Attach the wire harness clamp to the clamp bracket.

3. INSTALL V-RIBBED BELT

HINT: See: Engine, Cooling and Exhaust/Engine/Drive Belts, Mounts, Brackets and Accessories/Drive Belt/Service and Repair/Installation

4. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and

Replacement/Engine Assembly/Installation

5. INSTALL COOL AIR INTAKE DUCT SEAL See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine

Assembly/Installation

6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:  When disconnecting the cable, some systems need to be initialized after the cable is reconnected  See: Testing and
Inspection/Repair Instruction - Initialization.

Replacement

1AR-FE BATTERY / CHARGING: GENERATOR: REPLACEMENT

REPLACEMENT

1. REPLACE GENERATOR DRIVE END FRAME BEARING

(a) Remove the 4 screws and bearing retainer.

(b) Using SST and a hammer, tap out the bearing.

SST: 09950-60010
09951-00250
SST: 09950-70010
09951-07100