toyota Workshop Repair Guides

Toyota Workshop Service and Repair Manuals

Diagram Information and Instructions|Page 5679 > < Diagram Information and Instructions|Page 5677
Page 6
background image

-

Do not heat components to more than 60°C (140°F). Exceeding this temperature may damage the components.

-

Do not apply heat directly to parts in an ECU.

(c) WATER SPRINKLING METHOD: When a malfunction seems to occur on a rainy day or in high-humidity.

(1) Sprinkle water onto the vehicle and check if the malfunction occurs.
-

Never sprinkle water directly into the engine compartment. Indirectly change the temperature and humidity by spraying water onto the
front of the radiator.

-

Never apply water directly onto the electronic components.

HINT:  If the vehicle has or had a water leak problem, the leak may have damaged the ECU or connections. Look for evidence of corrosion or
short circuits. Proceed with caution during water tests.

(d) HIGH ELECTRICAL LOAD METHOD: When a malfunction seems to occur when the electrical load is high.

(1) Turn on the heater blower, headlights, rear window defogger and all other electrical loads. Check if the malfunction recurs.

5. DIAGNOSTIC TROUBLE CODE CHART

Look for output Diagnostic Trouble Codes (DTCs) (from the DTC checks) in the appropriate section's Diagnostic Trouble Code Chart. Use the
chart to determine the trouble area and the proper inspection procedure. A description of each of the chart's columns is shown in the table below.

6. PROBLEM SYMPTOMS TABLE

When no DTC is output but the problem still occurs, use the Problem Symptoms Table. The suspected areas (circuits or parts) for each problem
symptom are shown in the table. The suspected areas are listed in order of probability. A description of each of the table columns is shown in the
following table.

HINT:  In some cases, the problem is not detected by the diagnostic system even though a problem symptom occurs. It is possible that the
problem occurs outside the detection range of the diagnostic system, or that the problem occurs in a completely different system.

7. INSPECTION

A description of the main points for inspection of suspected areas is shown in the following table.

Diagram Information and Instructions|Page 5679 > < Diagram Information and Instructions|Page 5677