Venza AWD L4-2.7L (1AR-FE) (2009)
Bolt A, B, C: 11 N*m
(112 kgf*cm, 8 ft*lbf)
Torque:
Bolt D: 9.6 N*m
(98 kgf*cm, 85 in*lbf)
Bolt Length:
Bolt A: 25 mm (0.984 in.)
Bolt B: 30 mm (1.18 in.)
Bolt C, D: 35 mm (1.38 in.)
NOTICE
^
When installing the transmission valve body assembly, be careful NOT to allow the speed sensor and transaxle case to interfere with each other.
^
Be sure to insert the pin of the manual valve lever into the groove on the end of the manual valve.
^
First, temporarily tighten the bolts marked by (*1) in the illustration because they are positioning bolts.
7. Install the valve body oil strainer assembly.
A. Coat a new 0-ring with ATF and install it to the oil strainer.
NOTICE
Ensure that the 0-ring is not twisted or pinched.
B. Install the oil strainer to the valve body with the 2 bolts.
Torque: 9.6 N*m (98 kgf*cm, 85 in*lbf)
8. Install the automatic transaxle oil pan sub-assembly.