Venza AWD L4-2.7L (1AR-FE) (2009)
Front Door Window Regulator: Testing and Inspection
WINDOW / GLASS: POWER WINDOW REGULATOR MOTOR (for Front Door): INSPECTION
INSPECTION
1. INSPECT FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH
(a) Apply positive (+) battery voltage to connector terminal 2 (B).
NOTICE: Do not apply positive (+) battery voltage to any terminals other than terminal 2 (B) to avoid damaging the pulse sensor inside the
motor.
(b) Connect a ground lead to connector terminals 1 (GND) and 7 (DOWN) or 10 (UP).
(c) Check that the motor gear rotates smoothly as follows:
OK:
Text in Illustration
-
If the result is not as specified, replace the front power window regulator motor assembly LH.
CAUTION: Reset the power window regulator motor (initialize the pulse sensor) after installing the power window regulator motor
and regulator assembly onto the door.
2. INSPECT FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH