Venza AWD V6-3.5L (2GR-FE) (2010)
(d) Disconnect the cable from the negative (-) battery terminal.
(e) Insert the rear door glass sub-assembly into the rear door panel along the rear door glass run as indicated by the arrows, in the order shown in
the illustration.
(f) Install the rear door glass sub-assembly with the 2 bolts.
Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)
(g) Install the hole plug.
22. INSTALL REAR DOOR REAR GUIDE SEAL
(a) Install the rear door rear guide seal with the 2 screws.
23. INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY
(a) Install the temporary bolt to the rear door window division bar sub-assembly.
(b) Temporarily install the rear door window division bar sub-assembly.