Venza AWD V6-3.5L (2GR-FE) (2010)
Text in Illustration
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
5. INSPECT INDOOR ELECTRICAL KEY OSCILLATOR (for Front Floor (INPUT))
(a) Reconnect the certification ECU (smart key ECU assembly) connector.
(b) Check for pulses according to the value(s) in the table below.
Standard:
Text in Illustration
NG -- REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)
OK -- Continue to next step.
6. REPLACE INDOOR ELECTRICAL KEY OSCILLATOR (for Front Floor)
(a) Replace the indoor electrical key oscillator (for front floor See: Service and Repair/Electrical Key Oscillator (for Front Floor)/Removal.
NEXT -- Continue to next step.
7. CHECK SMART KEY SYSTEM (ENTRY IGNITION FUNCTION (for Front Floor))
(a) Inspect the detection area for the entry ignition function (for front floor). Make sure that the direction of the key is as shown in the
illustration. When the key is in either of the 2 inspection points shown in the illustration, check that the engine can start.