Venza AWD V6-3.5L (2GR-FE) (2010)
2. INSTALL TURN SIGNAL SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY See: Steering and Suspension/Steering/Steering
Column/Service and Repair/Removal and Replacement/Installation
3. INSTALL UPPER STEERING COLUMN COVER See: Steering and Suspension/Steering/Steering Column/Service and Repair/Removal and
Replacement/Installation
4. INSTALL LOWER STEERING COLUMN COVER See: Steering and Suspension/Steering/Steering Column/Service and Repair/Removal and
Replacement/Installation
5. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD
6. ADJUST SPIRAL CABLE See: Restraint Systems/Air Bag Systems/Clockspring Assembly / Spiral Cable/Service and Repair/Installation
7. INSTALL STEERING WHEEL ASSEMBLY See: Steering and Suspension/Steering/Steering Wheel/Service and Repair/Installation
8. INSTALL STEERING PAD See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Steering Pad/Installation
9. INSTALL LOWER NO. 3 STEERING WHEEL COVER See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Steering
Pad/Installation
10. INSTALL LOWER NO. 2 STEERING WHEEL COVER See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Steering
Pad/Installation
11. INSPECT STEERING WHEEL CENTER POINT
12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
13. INSPECT STEERING PAD See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Steering Pad/Installation
14. INSPECT SRS WARNING LIGHT
See: Restraint Systems/Air Bag Systems/Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnosis System