Venza AWD V6-3.5L (2GR-FE) (2010)
Removal
BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: REAR SPEED SENSOR (for AWD): REMOVAL
HINT
*
Use the same procedure for the LH side and RH side.
*
The following procedure is for the LH side.
*
If the sensor rotor needs to be replaced, replace it together with the rear drive shaft assembly.
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
2. REMOVE REAR WHEEL
3. REMOVE REAR DOOR SCUFF PLATE LH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal and
Replacement/Removal
4. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and
Repair/Removal and Replacement/Removal
5. REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover) See: Body and Frame/Interior Moulding / Trim/Headliner/Service and
Repair/Removal and Replacement/Removal
6. REMOVE DECK BOARD ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal and
Replacement/Removal
7. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal and
Replacement/Removal