Venza AWD V6-3.5L (2GR-FE) (2010)
Coolant Temperature Sensor/Switch (For Computer): Service and Repair
Removal
2GR-FE ENGINE CONTROL: ENGINE COOLANT TEMPERATURE SENSOR: REMOVAL
1. REMOVE NO. 1 ENGINE UNDER COVER
2. REMOVE NO. 2 ENGINE UNDER COVER
3. DRAIN ENGINE COOLANT See: Coolant/Service and Repair
4. REMOVE V-BANK COVER SUB-ASSEMBLY See: Engine/Service and Repair/Removal and Replacement/Engine Assembly/Removal
5. REMOVE AIR CLEANER CAP WITH HOSE See: Powertrain Management/Fuel Delivery and Air Induction/Throttle Body/Service and
Repair/Removal
6. REMOVE AIR CLEANER CASE See: Engine/Service and Repair/Removal and Replacement/Engine Assembly/Removal
7. REMOVE ENGINE COOLANT TEMPERATURE SENSOR
(a) Disconnect the engine coolant temperature sensor connector.
(b) Remove the engine coolant temperature sensor and gasket.