Venza AWD V6-3.5L (2GR-FE) (2010)
Coolant Temperature Sensor/Switch (For Computer): Service and Repair
Installation
2GR-FE ENGINE CONTROL: ENGINE COOLANT TEMPERATURE SENSOR: INSTALLATION
1. INSTALL ENGINE COOLANT TEMPERATURE SENSOR
(a) Install a new gasket onto the engine coolant temperature sensor.
(b) Install the engine coolant temperature sensor.
Torque : 20 Nm (204 kgf-cm, 15 ft-lbf)
(c) Connect the engine coolant temperature sensor connector.
2. INSTALL AIR CLEANER CASE See: Engine/Service and Repair/Removal and Replacement/Engine Assembly/Installation
3. INSTALL AIR CLEANER CAP WITH HOSE See: Powertrain Management/Fuel Delivery and Air Induction/Throttle Body/Service and
Repair/Installation
4. ADD ENGINE COOLANT See: Coolant/Service and Repair
5. INSPECT FOR COOLANT LEAK See: Testing and Inspection
6. INSTALL V-BANK COVER SUB-ASSEMBLY See: Engine/Service and Repair/Removal and Replacement/Engine Assembly/Installation
7. INSTALL NO. 2 ENGINE UNDER COVER
8. INSTALL NO. 1 ENGINE UNDER COVER