Venza AWD V6-3.5L (2GR-FE) (2010)
27. REMOVE CRANKSHAFT PULLEY See: Seals and Gaskets/Front Crankshaft Seal/Service and Repair/Removal
28. REMOVE FRONT NO. 1 ENGINE MOUNTING BRACKET LH See: Service and Repair/Overhaul/Disassembly
29. REMOVE WATER INLET HOUSING See: Service and Repair/Overhaul/Disassembly
30. REMOVE CYLINDER HEAD COVER SUB-ASSEMBLY (for Bank 1) See: Service and Repair/Overhaul/Disassembly
31. REMOVE CYLINDER HEAD COVER SUB-ASSEMBLY LH (for Bank 2) See: Service and Repair/Overhaul/Disassembly
32. REMOVE NO. 2 OIL PAN SUB-ASSEMBLY See: Service and Repair/Overhaul/Disassembly
33. REMOVE OIL STRAINER SUB-ASSEMBLY See: Service and Repair/Overhaul/Disassembly
34. REMOVE OIL PAN SUB-ASSEMBLY See: Service and Repair/Overhaul/Disassembly
35. REMOVE TIMING CHAIN COVER SUB-ASSEMBLY See: Engine Lubrication/Oil Pump/Service and Repair/Removal and
Replacement/Removal
36. REMOVE TIMING CHAIN CASE OIL SEAL See: Engine Lubrication/Oil Pump/Service and Repair/Removal and Replacement/Removal
37. SET NO. 1 CYLINDER TO TDC/COMPRESSION See: Service and Repair/Overhaul/Disassembly
38. REMOVE NO. 1 CHAIN TENSIONER ASSEMBLY See: Service and Repair/Overhaul/Disassembly
39. REMOVE CHAIN TENSIONER SLIPPER See: Service and Repair/Overhaul/Disassembly
40. REMOVE CHAIN SUB-ASSEMBLY See: Service and Repair/Overhaul/Disassembly
41. REMOVE IDLE SPROCKET ASSEMBLY See: Service and Repair/Overhaul/Disassembly
42. REMOVE CAMSHAFT TIMING GEARS AND NO. 2 CHAIN (for Bank 1)
(a) While raising the No. 2 chain tensioner assembly, insert a pin of 1.0 mm (0.0394 in.) diameter into the hole to hold the No. 2 chain tensioner
assembly.
(b) Using SST to hold the hexagonal portion of each camshaft, loosen the flange bolts of the camshaft timing gear assembly and the camshaft
timing exhaust gear assembly RH.
SST : 09922-10010