Venza AWD V6-3.5L (2GR-FE) (2010)
Crankshaft Main Bearing: Specifications
MAIN BEARING CAP TORQUE AND SEQUENCE
The crankshaft bearing cap bolts are tightened in 2 progressive steps.
Step 1
Install and uniformly tighten the 16 crankshaft bearing cap bolts in several steps and in the sequence shown in the illustration.
Torque.......................................................................................................................................................................................61 Nm (622 kgf-cm, 45 ft-lbf)
If any of the crankshaft bearing cap bolts does not meet the torque specified, replace it.
Step 2
Mark the front of the bearing cap bolts with paint.
Retighten the bearing cap bolts 90° in the sequence shown in the illustration.
Check that the painted mark is now at a 90° angle to the front of the engine.
Install 8 new seal washers and uniformly tighten the 8 crankshaft bearing cap bolts in several steps and in the sequence shown in the illustration.
Torque.......................................................................................................................................................................................52 Nm (525 kgf-cm, 38 ft-lbf)
Bolt Length:
Check that the crankshaft turns smoothly.
MAIN BEARING SIZE CODES