Venza AWD V6-3.5L (2GR-FE) (2010)
Intake Manifold: Service and Repair
Installation
2GR-FE INTAKE / EXHAUST: INTAKE MANIFOLD: INSTALLATION
1. INSTALL INTAKE MANIFOLD
(a) Set 2 new intake manifold to head gaskets on each cylinder head.
NOTICE:
*
Align the port holes of the gaskets and cylinder head.
*
Make sure that the gaskets are installed in the correct direction.
(b) Set the intake manifold on the cylinder head.
(c) Install and tighten the 6 bolts and 4 nuts uniformly in several steps.
Torque : 21 Nm (214 kgf-cm, 15 ft-lbf)
2. INSTALL FUEL INJECTOR ASSEMBLY See: Powertrain Management/Fuel Delivery and Air Induction/Fuel Injector/Service and
Repair/Installation
3. CONNECT FUEL TUBE SUB-ASSEMBLY See: Powertrain Management/Fuel Delivery and Air Induction/Fuel Injector/Service and
Repair/Installation
4. INSTALL NO. 2 ENGINE MOUNTING STAY RH See: Service and Repair/Removal and Replacement/Engine Assembly/Installation
5. INSTALL INTAKE AIR SURGE TANK ASSEMBLY
NOTICE:
DO NOT apply oil to the bolts listed below:
(a) Install 3 new air surge tank to intake manifold gaskets to the intake air surge tank.
(b) Using a 5 mm hexagon socket wrench, install the intake air surge tank assembly with the 4 bolts and 2 nuts.
Bolt - Torque : 18 Nm (184 kgf-cm, 13 ft-lbf)
Nut - Torque : 16 Nm (163 kgf-cm, 12 ft-lbf)