Venza AWD V6-3.5L (2GR-FE) (2010)
Torque : 9.8 Nm (100 kgf-cm, 87 in-lbf)
3. CONNECT COOLER REFRIGERANT DISCHARGE HOSE
(a) Remove the attached vinyl tape from the pipe and the connecting part of the cooler condenser assembly.
(b) Sufficiently apply compressor oil to a new O-ring and the fitting surface of the pipe joint.
Compressor oil:
ND-OIL 8 or equivalent
(c) Install the O-ring on the discharge hose.
NOTICE:
Keep the O-ring and O-ring fitting surfaces clean from dirt or any foreign objects.
(d) Install the discharge hose on the cooler condenser assembly with the bolt.
Torque : 9.8 Nm (100 kgf-cm, 87 in-lbf)
4. INSTALL UPPER RADIATOR SUPPORT See: Engine, Cooling and Exhaust/Cooling System/Radiator/Service and Repair/Installation
5. INSTALL HOOD LOCK SUPPORT SUB-ASSEMBLY
(a) Install the hood lock support sub-assembly with the 2 bolts.