Venza AWD V6-3.5L (2GR-FE) (2010)
Engine Control Module: Service and Repair
Removal
2GR-FE ENGINE CONTROL: ECM: REMOVAL
NOTICE:
Perform the Vehicle Identification Number (VIN) registration when replace the ECM See: Testing and Inspection/Programming
and Relearning/Repair Instruction - Initialization.
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
2. REMOVE V-BANK COVER SUB-ASSEMBLY See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and
Replacement/Engine Assembly/Removal
3. REMOVE ECM
(a) Disconnect the 2 ECM connectors and remove the ECM with the brackets.
NOTICE:
After disconnecting the connectors, make sure that dirt, water or other foreign matter does not contact the connecting part of the
connectors.
(1) Push in the locks on the 2 levers, raise the levers, and disconnect the 2 ECM connectors.
(b) Remove the 3 nuts and separate the ECM with the brackets.
(c) Remove the 4 screws and 2 ECM brackets.