Venza AWD V6-3.5L (2GR-FE) (2010)
Standard Resistance:
Text in Illustration
Text in Illustration
NOTICE:
When the measured value is 133 Ohms or higher and a CAN communication system DTC is output, there may be a fault besides
disconnection of the DLC3 branch wire. For that reason, troubleshooting should be performed again from How to Proceed with
Troubleshooting after repairing the trouble area See: Initial Inspection and Diagnostic Overview/CAN Communication System/How
to Proceed With Troubleshooting.
NG -- REPAIR OR REPLACE CAN BRANCH WIRE CONNECTED TO DLC3
OK -- Continue to next step.
2. CHECK FOR OPEN IN CAN BUS WIRE (ECM)
(a) for 1AR-FE engine:
(1) Disconnect the ECM connector (A49).
Text in Illustration
Text in Illustration
(2) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
(b) for 2GR-FE engine:
(1) Disconnect the ECM connector (A41).